Magnum-dynalab MD-105 User Manual download pdf (Page 8)

- 8 -

CHECKING OUT YOUR MD 105

1. Place your power switch to the “ON” position. This should turn on your tuner’s

meter lights and frequency display.

2. Place your STEREO/MONO switch to the Stereo setting.

3. Place your bandwidth switch to BW1.

4. Place your Mute switch to “ON” position.

5. On your preamplifier/ integrated amplifier select the input that your MD 105

tuner is connected to.

6. Rotate the tuning knob on your tuner until sound is heard through your

speakers. Now fine tune this station using the center tuner meter and signal

strength meter as indicators. Your stereo light on the face of your tuner

should be on. Place the stereo/mono to the Mono position, your stereo light

should now go off. Now turn the stereo/mono switch back to the Stereo

position and your stereo indicator light should turn back on.

7. You are ready now to search through FM frequencies in search of your

favorite stations. If you encounter difficult reception situations please read the

Controls and Functionality section of your manual.

8. Approximately 48 hours of “burn in” should eliminate any measure of drifting

that you may encounter with your new tuner. Please note that when your tuner

is turned off for more than a couple of hours, upon powering “ON” your tuner,

you may encounter a slight amount of drift on the station you were last tuned

to. Please do not touch the dial, as when the tuner warms back up, it will

return to where it was last center tuned.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

Magnum-dynalab MD-105 User Manual Page 8